Fasep 2000 srl
Rev. 1.3
Videotronic V653.G2: User’s Manual
02 april 2010
B-1
B:
Environmental Data, Safety Features and Requirements
Environmental Data
[
Operating conditions
]
This unit is designed for indoor use only.
Temperature:
0 to 45
/
C
Relative Humidity:
5 to 80% a 40
/
[
Storage conditions
]
Package is designed for indoor storage only.
Temperature:
-25
/
to 70
/
C
Relative humidity:
5 at 95% to40
/
C
Safety Features
1.
The Balance Weights Holder may be removed for servicing. It is secured to the machine body through screws so that only
voluntarily it may be removed. Removal of this protection is therefore restricted to Authorized Service Engineers.
2.
The Control Panel may be removed for servicing. It is secured to the machine body through screws so that only voluntarily
it may be removed. Removal of this protection is therefore restricted to Authorized Service Engineers.
!
CAUTION:
The safety cover is anyway required when using the motorcycle adapter.
WARNING
FASEP 2000 srl shall not be responsible for any inconvenience, breakdown, accidents caused
directly or indirectly by unauthorized service. Service to any parts by unauthorized engineers will void
warranty and will any right of the owner of the unit..
NOTE:
As this unit runs at speed below 100rpm, a safety cover is not required. However a safety cover is
recomended when balancing wheels with diameter bigger then 20".
General Safety Requirement
[
before using/servicing this unit
]
1.
Read this instruction sheet and the whole user’s manual before operating or servicing the wheel balancer.
2.
Make sure electrical power source conforms to requirements shown on nameplate (see also model identification chart
for reference).
3.
Make sure the unit has a stable position.
[when using the unit]
4.
Protect power leading to the unit from damage.
5.
When work area is being washed, make sure unit is adequately protected.
6.
Remove all stones and mud lodged in tire treads before balancing the wheel.
7.
Do not touch spinning wheel. Always use Safety Safety cover to be protected.
8.
Make sure counterweights are securely attached before checking residual umbalance.
[when servicing the unit]
9.
Make sure power sources are disconnected before service on the unit is performed.
10.
Service to PCB, electrical and mechanical parts should be done only by an Authorized FASEP 2000 Service Center.
