www.fassride.com
(866) 769.3747
STEP 2:
PREPARE SUCTION &
RETURN LINES
C.
Disconnect factory suction and return lines (refer to diagram at the beginning of step 2).
D.
With the fuel tank empty of fuel, unbolt the tank straps and remove it from the vehicle.
E.
Remove and discard the fuel tank module shield, this will no longer be used.
Clean the fuel module area then remove the lock ring on the top of the fuel tank.
This is spring loaded,
so, holding it down while removing the ring will prevent the sending unit from popping up and
possibly causing damage.
F.
Note the location of the tab and arrow. Re-install the sending unit in the same location to prevent the
fuel level arm from binding.
Remove fuel tank module from fuel tank, be careful not to damage fuel level
float.
