www.fassride.com
(866) 769.3747
STEP 3:
MOUNT FUEL SYSTEM
Fuel Filter –Install FF-3003
on side of pump with draw
tube in the middle of the
filter nipple.
Water Separator Filter –Install FS-1001 on
water separator nipple without the draw
tube. Make sure to insert O-Ring provided
on nipple.
Note: O-Ring must be put back on suction side of pump. Failure
to do so can result in priming issues, cavitation, or pressure loses.
NOTE: If fuel pressure gauge is pulsating after FASS installation, use snubber
valve (Cat Part # 7S-3795)