39
Fig. 29 TRAVEL PATTERN (BROADCAST)
18.
For broadcast spraying:
It is recommended that the operator make
one pass around a field to start and then
spray back and forth to obtain the best
results. Using a marker system helps to
prevent skips or overlap.
If your field has headlands, be sure to allow
sufficient space for turning.
19. For row crop spraying, start at one edge of
the field and go back and forth until the field
is completed.
20. Be sure the sprayer is calibrated, the nozzle
height and pressure are known and the
tractor gear and RPM are determined before
starting to spray (see Section 4.9).
Fig. 31 SPRAYING
Fig. 30 CONTROL BOXES (TYPICAL)
21. Proceed down the field at a
constant speed. Use the se-
lected gear, engine RPM and
ground speed determined during
the calibration of the machine
application rate.
22. Place the Master Boom switch in
the OFF position and the appro-
priate Boom switches in the ON
position.
23. Turn the booms ON with the
Boom Master switch as the
nozzles pass over the edge of the
already sprayed headland and
come to the area to be sprayed.
Use the individual boom switches
as appropriate when finishing a
field.
24. When completing a pass and
approaching the sprayed head-
land, maintain the tractor RPM
and ground speed until the
nozzles have covered all the
plants. This will insure a
consistent application rate at
the ends of the field.
Summary of Contents for Fast Sprayers 9500 Series
