5.2 MAINTENANCE
By following a careful service and
maintenance program for your
machine, you will enjoy many years
of trouble-free operation.
5.2.1 FILTER CLEANING
The fluid in the sprayer is continually
being filtered through a screen filter in
the boom control feed line, agitation
and boom feed lines. The sprayer
must have clean water to prevent
clogging of the screens and check
valves when in use. These screens
must be cleaned daily or more often
as required. To clean, follow this
procedure:
1. At the start of each day before
the water and chemicals are
added, the screens should be
checked and cleaned.
2. If there is water or solution in the
sprayer, close Valve 2 to isolate
the screens.
3. Loosen the filter bodies by hand.
Do not use a wrench as this
could damage the filter body.
4. Remove the screens and inspect
them for dirt.
5. Clean them using clean water.
6. Inspect for holes or tears. If there
is damage, replace it.
7. Install the screens and body to
the filter heads and tighten by
hand. Do not use a wrench as
this might damage the body. Do
not over tighten and crack the
head.
8. Open the ball valves to allow the
solution to circulate.
9. Drain all screens before storage
to avoid freezing.
Schematic
Boom Line (Typical)
68
Fig. 68 SCREENS
Boom Feed
Summary of Contents for Fast Sprayers 9500 Series
