Flip Control:
*Tip - Make sure the nebula cruiser is hovering at least 9 feet from the ground before attempting flips.
While hovering, move directional control stick in any extreme direction and press the flip button.
Nebula Cruiser will flip in the direction that the joystick is pointed.
Trimming and calibrating:
Flight adjustments may be needed depending on environment, ground surface, wind, etc.
To trim and calibrate your Nebula Cruiser, run these tests and make adjustments just as your aircraft
becomes airborne (within 12" from the ground).
1.
To correct spin, slowly tap the "Direction Trim" switch in the direction you wish the Nebula Cruise to go.
2.
To correct forward or backward movement, tap the "Forward and Backward Trim" switch in the direction you want the
Cruiser to go. Tap the “Trottle Trim” switch to accomplish same forward or backward movement.
3.
To correct excessive movement to the left or right, tap the "Side Trim" switch in the direction
you want the Nebula Cruiser to go.
Troubleshooting:
Issue
Solution 1
Solution 2
Solution 3
After trim adjustments, craft
continues to fly sideways or
out of control
Check to make sure
propellers are assembled
onto correct motors.
Check to make sure no hair,
string, etc. is caught in the
propeller
Check propeller to make sure
they turn freely and are not
damaged
Aircraft does not take off
Reset syncronization (see
instr. pg. 3)
Install fully charged batteries
into drone and remote
Make sure you are within the
12 feet range and there is not
obstruction or interference
After hard landing, propeller
does not spin
Inspect propeller and
replace any propeller
that is damaged
If propeller does not turn,
there may be damage to the
rotor. Contact manufacturer
for replacement
Replacement parts are available for purchase directly from the dealer or at
For additional questions or support please contact
4