FMT3032
Instruction Manual
Fast Mover Tools Limited
T: 01582 661993 F: 01582 667100 E: sales@fastmovertoolsuk.com
W: www.fastmovertoolsuk.com
Please look after the environment, dispose of all packaging in a responsible
way. Always dispose of tools in accordance with local authority guidelines.
© 2014 Fast Mover Tools Ltd. This document is copyright and is not to be copied, circulated,
distributed or shown to anyone other than the intended recipient without the express permission of
the directors.
Air Filter
1
Dirt, water, and the lack of pneumatic tool oil are major causes for tool wear.
2
Install an optional air filter (not supplied), as illustrated below for better performance.
3
Connect the Pneumatic Paint Shaker, air hose, filter, to the Compressor Air Outlet.
General Safety Instructions
Warning: Verify that the paint containers are securely closed before shaking,
to avoid spilling or property damage. Make sure there is oil in Oiler (3)
BEFORE use. See below.
1
Place the paint can within the Jaws (54) and securely tighten Handle (44).
2
Verify that the Control Valve (1) is in the Off position (handle perpendicular to air flow
direction).
3
Turn on the air pressure at the air supply tank or compressor. Adjust pressure to 40 PSI
as read on the compressor pressure gauge.
4
Adjust the air pressure up to a maximum of 70 PSI for optimum tool performance.
5
Turn the Control Valve (1) to the On position. Shaking will begin.
Caution: If the paint can appears to be slipping out from the Jaws (48) during shaking,
immediately turn off the Control Valve (1). Reset the can and re-tighten the Jaws.
6
Shake the paint can for two to four minutes, depending on its size.
7
After mixing the paint, turn the Control Valve (1) to the Off position, and wait for the
movement to stop.
8
Disconnect the air hose from the compressor.
9
Loosen Handle (44) and remove the paint can.
Maintenance
General
1
After each use, remove the air hose and wipe the tool with a clean cloth to remove any
dirt and grease buildup.
2
To maintain tool life, always lubricate the air line by adding a few drops of pneumatic tool
oil to the air line before each use. Or, install the automatic oiler-filter system.
3
Before each use, drain water out of the air compressor tank and condensation from the
air lines. Refer to the Air Compressor Operator’s Manual.
Lubrication
1
Disconnect the Pneumatic Paint Shaker from the air supply.
2
Locate the Oiler (3). There is a plug and a small screw on the Oiler that must be
removed. Using a small funnel, pour air tool oil into the fill hole until the oiler is full.
Replace the Fill Screw and plug.
3
Connect the Pneumatic Paint Shaker to the Oiler (3). The oiler will automatically spray a
very small amount of oil into the Paint Shaker as you use it. Make sure you keep oil in
the Oiler (3) to avoid damaging the Paint Shaker.
4
There is a zerk oil fitting (35) that feeds oil to a Bushing. Lubricate the bushing at least
once a month if heavily used.
