FT1068
Instruction Manual
Fast Mover Tools Limited
T: 01582 661993 F: 01582 667100 E: sales@fastmovertoolsuk.com
www.fastmovertoolsuk.com
Fig. 1
Air Filter/Regulator
/Lubricator
Whip
Hose
Airline
Air Fitting
Quick Release Air Coupling
To Air Tool
Fig. 2
We recommend that your air tool is connected to the
main airline in the way displayed in Fig. 2.
1: Air Tool
2: Whip Hose/Leader Hose
3: Air Fitting
4: Quick Coupling
5: Main Air Hose
5
1
4
3
2
Air
Source
Familiarise Yourself with the Controls
1
The throttle is pressure sensitive. Applying pressure will increase rotational speed.
2
Removal of all pressure will stop the machine.
3
Some models are fitted with a safety lock to prevent accidental starting. IF FITTED, this
should be locked at all times when the polisher is left under power.
4
Never leave the tool unattended and connected to the power supply.
During Use
1
When using the polisher for long periods of time, check the polishing pad for wear.
2
Replace worn pads as worn or clogged pads will make the polisher inefficient.
3
The polishing operation will cause heat. Check the material that is being worked on that
it is not getting too hot. If this is occurring, stop polishing to allow the material to cool
down.
4
You can adjust the speed of the tool by adjusting the pressure you apply to the throttle.
5
Make regular checks on the polishing pad for wear and damage and replace them
immediately.
6
Due to the potential heat caused by the polishing process, keep flammable liquids and
gases well away from the work area.
Installation
1
Check the tool over to make sure no part is missing or damaged.
2
Fitting an Air Filter, Regulator and Lubricator is recommended.
3
Refer to
Fig. 1
for the recommended airline setup.
FT1068_Product Instructions 21/07/2014 14:39 Page 4
