25
Fresh Water Rinse Tank:
11.
Each machine is equipped with a fresh water rinse tank
(B) on rear frame. Fill rinse tank with clean fresh water
whenever rinse water has been used. Do not allow
tank to run low on fresh water. Use water from rinse
tank to clean, rinse or wash anything that has become
contaminated.
Ground speed:
12.
It will be necessary to establish travel speed and then
set flow to give desired application rate. Always run at
established travel speed.
However, best results are obtained ground speed is
5 - 8 mph. Ground speed variations in the field will
automatically be compensated. Always operate at a
comfortable speeds. Do not operate so fast that tool
bar or tank bounce while going through field. Effective
results require that liquid be applied at a consistent
depth in a consistent manner. Machine bouncing will
prevent this required consistency.
Unfolding/Extending Tool Bar:
13.
Verify tool bar is fully raised.
•
^
WARNING
Prevent serious injury or death.
Machine coming near or contacting power
lines can cause electrocution.
Electrocution can occur without contact.
Fully lower wings before moving or
transporting.
NOTICE
Prevent wing rest damage.
Never engage tractor remote lever to lower
center section (orange labeled hose) while
main wings are in transport position.
Move tractor remote lever (grey labeled hose) to
•
raise center section and main wings (C) up off wing
rest (D).
Move tractor remote lever (purple labeled hose) to
•
detent to supply continuous oil flow to electronic
fold box functions.
Move latches switch (E) to transport position for
•
a few seconds to be certain wing latches are fully
raised. Verify latches are fully raised.
Move main wing switch (F) to field position and hold
•
until wings are unfolded. Wings will be laterally in
line with center section when fully unfolded.
MAIN WINGS
DOWN IN REST
FLIP WINGS
LATCHES
DANGER: Never unfold toolbar under overhead wires
WARNING: Always lock toolbar before transport
E
FIELD
TRANSPORT
F
