LUBRICATION & MAINTENANCE
LUBRICATION & MAINTENANCE
3PT Sprayer 973PT
Page 66
Re-refined base stock products may be used
if the finished lubricant meets the
performance requirements.
Lubrication and Maintenance
Intervals
Perform each lubrication and service
illustrated in this section. Use a hand-held
grease gun for all greasing.
Wipe the implements’ grease fittings with a
clean cloth before greasing to avoid injecting
dirt or debris. Replace broken fittings
immediately.
If a fitting will not accept grease, remove and
clean it thoroughly or replace it. Clean the
passageway.
Each 10 hours or Daily
•
Clean the Strainer
o
It is recommended that the
fertilizer strainer screen be
removed and washed with
clean freshwater every 8
hours.
•
Clean the boom feed line 50-mesh
and pump filters (3 or more
depending on options).
•
Grease the center pivot pin (2 places)
•
Grease the boom tilt pivots (1/boom)
•
Grease the parallel linkages (4 links,
8 places total)
Summary of Contents for AG SOLUTIONS 973PT
