If Equipped With Electric Control Rinse System:
Page 57
HYDRAULIC DRIVE PUMP (OPTIONAL)
If Equipped With Electric Control Rinse
System:
• Locate the electric rinse control switch on
the tractor control box and move the
switch to the “Product Tank” position.
3. Slowly open the “Fast Fill” valve,
marked as “Valve F” and let run until the
product tank is full, turn off the “Fast Fill”
valve. There is a breather on the product
tank lid to allow air to escape during the
filling operation.
IMPORTANT:
If you are filling with a high
volume transfer pump, it may be
necessary to remove the center lid from
the manhole cover.
4. Close the “Fast Fill” Valve.
5. Disconnect the fill hose and replace the
dust cap. Use care when removing the fill
hose from the connector, there could still
be liquid in the line.
6. Replace the center lid on the manhole
cover, if it was removed.
Filling With Sprayer Pump
Your sprayer has the ability to fill itself by
using the sprayer product pump.
Your sprayer is equipped with a 2” male
fast fill connector and a ON/OFF valve
(identified as “Valve F”) located on the left
side of the sprayer, directly behind the
step.
Fill as follows:
1. Connect the fill hose to the 2” connec-
tor.
2. Open the water supply valve to fill the
hose.
IMPORTANT:
The water source MUST be
higher than the sprayer pump. NEVER run
the sprayer pump dry. The sprayer pump
will not draw water from a source lower
than the pump, until the pump is primed.
If Equipped With Manual Control Rinse
System:
• Turn the manual three way ball valve
identified as “Valve E” (located under the
platform on left side of sprayer) to the
“OFF” position (handle pointed down).
If Equipped With Electric Control Rinse
System:
• Located under the operator platform on
the left side of the sprayer is an electric
three way ball valve. Directly behind this
valve is a manual ON/OFF valve with a
yellow handle. Turn this valve OFF
(handle should point toward rear of
sprayer). When handle is pointed toward
right side of sprayer the valve is ON.
3. Open the “Fast Fill” valve marked as
“Valve F.”
4. Start the product pump and run at full
Summary of Contents for BW500
