28
Raven Rate Controller (Optional):
a.
Connect the RED wire directly to the battery (12
volt - positive). DO NOT connect to a remote power
source.
b.
Connect the WHITE wire directly to the battery (12
volt - ground). DO NOT connect to a remote ground
source.
c.
The Raven rate controller will need to be programed.
See Raven rate controller manual for proper
procedure. Verify the values and note them in the
controller book for reference.
6.
Complete the final assembly and make the final
connections. Test system to make sure it is working
properly.
5.5 Hydraulic Hose Connections - Boom
Control
There are three types of booms available for your sprayer.
• EF Hydraulic fold with boom width of: 45 ft.
• EFT Hydraulic fold & wing tilt with boom width of: 45 ft.
• HC Hydraulic fold with boom width of: 60 ft.
^
WARNING
Hydraulic oil under pressure can spray into eyes
and cause physical injury.
Follow tractor operator manual instructions for
shutting off hydraulic supply and relieving hydraulic
pressure before connecting or disconnecting
hydraulic hoses.
5.5.1 EF & EFT Boom Hydraulic Hose Connec-
tions
1. The EF & EFT boom utilizes three separate hydraulic
hoses which must be connected to the appropriate
couplers on the tractor. All three male tips are an ASAE
standard tip (Pioneer).
• The single hose will operate the entire boom UP or
DOWN & for EFT boom with switch activated will tilt left
wing UP or DOWN.
• The pair of hoses will operate the fold IN or OUT & for
EFT boom with switch activated will tilt right wing UP or
DOWN
2.
The hoses on the sprayer are marked with colored tie
wraps to identify the hoses for proper connection to the
tractor. The pair of hoses for the fold IN or OUT will have
one color and the boom UP or DOWN will be another
color.
3.
There is an extra set of the colored tie wraps shipped
with your sprayer. Attach these tie wraps to the proper
tractor hydraulic couplers to aid in the correct reattaching
of the sprayer hydraulic hoses.
Note: If sprayer is being hitched to the tractor for the first
time, charge the sprayer hydraulic system with oil.
IMPORTANT: The storage slots for the hydraulic hoses
should ONLY be used when sprayer is disconnected from
the tractor and being stored. Hydraulic hoses MUST always
be connected to tractor during transport of sprayer.
5.5.2 EFT Boom Electrical Connections
There are three wires that are to be connected to the tractor.
1. Connect the two RED wires to the positive (+) 12
volt power source of the tractor. The RED wires can
be connected directly to the battery or to an auxiliary
connection such as the fuse block.
2. Connect the WHITE wire to the negative (-) ground
source of the tractor. The WHITE wire can be connected
directly to the negative battery or to an auxiliary
connection as long as a good ground is maintained.
5.5.3 HC Boom Hydraulic Hose and Electrical
Connections
Your sprayer has been shipped from the factory set-up
for use with a tractor that has “Closed Center” Hydraulics.
Determine if your tractor has this type of hydraulics. Connect
sprayer hydraulic hoses to the tractor hydraulic system.
When the HC boom is in use, the hydraulic valve on the
tractor MUST be locked open to assure a constant supply
of oil to the cylinder valve control bank located at the back
of the sprayer.
Summary of Contents for BW750
