LUBRICATION & MAINTENANCE
LUBRICATION & MAINTENANCE Utility Sprayer 25' / 30' / 40' / 45'
Page 88
Foam Row Marker Maintenance
All electrical components generate
heat. To avoid serious burns, never
touch
internal
components
immediately after use.
The air compressor in this unit may be
thermally
protected
and
may
automatically restart when the
protector resets. Always disconnect
the power source before servicing.
Wear goggles and all protective
clothing when operating, servicing, or
refilling this machine. Always read
and
follow
manufacturer
recommendations when handling any
chemical.
Do not remove covers or attempt
repairs while connected to electrical
source.
Disassembly or attempted repairs, if
accomplished incorrectly, can create
hazards. Only qualified personnel
should perform repair service.
Foamheads and Screen/Strainer
The foamheads have been designed so that
the elements inside may be cleaned as
necessary. Remove the foamheads from the
boom and rinse thoroughly with hot water.
The screen/strainer located in the tank
should be checked occasionally to ensure
sufficient liquid flow to the foamhead
assemblies.
Tank and Hoses
At the end of the season, flush the tank with
warm water. Check the air- and liquid-lines
for holes and replace as required. Be sure to
flush, then drain, all liquid from the system
prior to storage in freezing temperatures.
IMPORTANT: The liquid lines and tank
must be drained completely prior to
storage. If liquid in this system is
allowed
to
freeze,
several
components may be damaged.
Summary of Contents for UT3P25
