PREPARING FOR STORAGE
PREPARING FOR STORAGE
Utility Sprayer 25' / 30' / 40' / 45'
Page 96
PREPARING FOR STORAGE
CAUTION: Store the unit in an area
away from human activity. Do not
permit children to play on or around
the stored Sprayer.
At the end of the season, thoroughly inspect
and prepare the Sprayer for storage. Repair
or replace any worn or damaged
components to prevent any unnecessary
downtime at the beginning of next season.
IMPORTANT: The tank is made from
polyethylene. Do not use or store
petroleum products on or in the tank.
They will be absorbed into and soften
the plastic.
1.
Thoroughly wash the machine to
remove all dirt, mud, debris, and
residue to protect against corrosion.
2.
Empty any remaining liquid from
tank. Flush the entire system with
clean freshwater.
3.
Drain all fluids out of the system. See
4.
Lubricate all grease points. Make
sure all grease cavities have been
filled with grease to remove any
water residue from washing. See
5.
Inspect all hydraulic hoses, couplers,
and fittings. Tighten any loose fittings.
Replace any hose that is damaged or
is separating from the crimped end of
a fitting.
6.
Inspect all liquid lines and
connections. Tighten any loose
fittings. Replace any line that is cut,
nicked, or abraded.
7.
Touch up all paint nicks and
scratches to prevent rusting.
8.
Fold the inner and outer wings to the
transport configuration.
9.
Move the machine to a storage
location that is dry, level, and free of
debris.
10.
Avoid leaving the Sprayer in direct
sunlight (ultraviolet radiation) for
extended periods of time.
11.
Unhook Sprayer from tractor.
Winterization
1.
Remove the line caps at the end of
the stainless-steel wet booms.
2.
Connect an air compressor and blow
the lines out until no water remains.
3.
Replace the end caps.
4.
Add approximately 38 L (10 gal) of
RV antifreeze per 3 m (10 ft.) of
toolbar.
5.
Flush the system, then pump through
screens, valves, nozzles, check
valves, and orifices/tips.
For the Foam Row Marker
1.
Completely flush the foam tank with
warm water.
2.
Turn on the machine and allow it to
operate until no foam is generated.
3.
Add anti-freezing solution such as
windshield washer solvent to tank.
Summary of Contents for UT3P25
