- 15
The GFCI unit has an LED light to let you know that the device is working. If the
GFCI cannot be reset or if the GFCI unit trips immediately after being reset, call
Fastcorp Service at (888) 441-3278.
SHIPPING BRACKETS
The Evolution Vendor makes use of shipping brackets to protect the Robot Arm
and the Freezer Lid during shipping. It is necessary to install these brackets
each time the machine is transported to or from location. Both shipping brackets
have been recently modified to make the brackets more user friendly and to
make installation possible without the use of tools.
Freezer Lid Shipping Bracket Removal Instructions:
1. The original Freezer Lid Shipping Bracket consists of a metal plate that uses
(2)
screws to fasten it to the
top
of the Freezer Lid Lift Mechanism on the right
side of the cabinet. The (2) retaining screws can be removed using a 5/16-inch
socket wrench.
2. The current Freezer Lid Hold Down makes use of a red cable tie to prevent
the Freezer Lid from opening during shipping. The cable tie wraps around the
Freezer Closed Switch Actuator Plate and the
Freezer Closed Switch Mounting
Bracket on the right front of the Freezer. Carefully cut the red cable tie and
manually lift the freezer lid to make sure there are no obstructions.
Both Freezer Lid hold down mechanisms work well and can be used
interchangeably.
Robot Arm Shipping Bracket Removal Instructions:
1. The original Robot Arm Shipping Bracket is a metal bracket that supports the
Robot Arm during shipping and mounts to the cabinet ceiling on the right side of
the machine. The bracket provides a pocket that holds the arm stationary with
the use of (2) small clamps. Each clamp makes use of (2) retainer screws.
Using a 5/16-inch socket wrench, remove the (2) front clamp retaining screws
and loosen the retaining screws on the rear clamp. Slide the end of the Robot
Arm forward and out of the rear clamp. The bracket is fastened to the ceiling of
the cabinet with (2) nuts that can be removed using a 7/16-inch wrench. The
bracket and hardware can then be secured in a safe place for future use.
WARNING:
After the Robot Arm Shipping Bracket has been removed, (2)
additional nuts will become visible. These nuts MUST remain in place.
The remaining nuts on the ceiling of the cabinet are the fasteners for the upper
door hinge.
2. The current Robot Arm Shipping Bracket makes use of a Styrofoam clamshell
held in place with a 36.5-inch long cable tie. The shipping bracket can be
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
