IL3 User’s Guide
page 14
11S-3002B
3-3 WiFi Setup
The “WiFi Config...” element in the Fas
M
otion
Configuration menu will only appear if the attached
camera is in Live mode and has been factory licensed for
WiFi and has it’s WiFi dongle attached via its USB port.
Note: The camera may not be operated via WiFi in
Fas
M
otion. The WiFi configuration utilities are present
in Fas
M
otion to satisfy the setup requirements for the
IL3, which does not have an alternate method for WiFi
setup as it has no camera GUI and the Web-App does not
include a network setup.
WiFi Setup for an Existing Network
1. Select WiFi Config... from the Configuration Menu.
2. Click on the Scan button to see a list of local WiFi
networks.
3. Select a network from the “Select WiFi Access Point”
dialog. You will most likely wish to leave DHCP
selected unless you are familiar with the network
and wish to supply a valid IP address, net mask, and
gateway.
4. Type in the password, if needed and then click on
OK. The dialog will close.
5. If you selected DHCP, you can re-open the WiFi
configuration dialog after a few minutes and you will
see the assigned IP address for the camera.
WiFi Setup for an Ad Hoc Network
1. Select WiFi Config... from the Configuration Menu.
2. Click on the Manual button. This will allow you to
edit the name in the SSID box. Make up a unique
name for your network and enter it here.
3. Check the Ad Hoc checkbox and then, leaving the
DHCP radio button selected, click on OK.
4. The dialog box will close. If you reopen it in a couple
of minutes you will be able to read the IP address
assigned to the camera.
Connecting to the TS3 via WiFi
1. Open the Wireless network settings utility on your
computer or mobile device. You will see a list of
available wireless networks.
2. From this list, select the wireless network the TS3 is
using as seen in the WiFi line in the camera’s System
Menu.
3. Enter the password, if any.
The IL3 and your computer or mobile device are now
both connected to the same wireless network. Follow
the instructions in “3-8 Connect to the IL3 Outside
FasMotion” on page 19 to use the IL3 wirelessly with
the Web-App.
Figure 3-8:
Configuration Menu with WiFi
Figure 3-9:
WiFi Configuration Dialog
Figure 3-10: WiFi Access Point Scan Dialog
