19
FASTORA DAS-208CC Disk Array
4. Change the setting of the terminal to match the default settings of the
FASTORADAS-208CC, namely:
Baud
rate:
115,200
Data bit: 8
Stop bit: 1
Parity:
None
Flow Control: None
You shall see a pop-up screen indicating that the connection has been setup
successfully. Then, you may configure the disk array with your terminal. Refer to
section
3.2.3 Control Key Definition under ANSI Terminal
to learn the control keys
for terminal emulation.
Please note that if you wish to start to configure with your terminal as quickly
as possible, you may refer to
Section 4.1.2 Quick setup via Terminal
Configuration
.
3.2.2 Using PC for Terminal Emulation
If you do not have a dedicated terminal, you can still use a PC configured as a
terminal, running a terminal emulation program. Microsoft Windows and
Windows 95 both have built-in terminal emulation support. Please select ANSI
terminal as the terminal type for the terminal emulation. You can also use other
terminal emulation programs such as KERMIT or VTERM. If you cannot see
anything on the screen after the session has been established, press TAB key
followed by Ctrl-D key combination to refresh the screen.
Follow the same steps discussed in section
3.2.1 Connecting a Terminal
to
connect your PC to the disk array.
Summary of Contents for DAS-208CC
Page 1: ...FASTORA DAS 208CC Disk Array User Guide For Ultra160 to Ultra160 RAID Subsystem V 1 0a ...
Page 23: ...23 FASTORA DAS 208CC Disk Array 3 4 1 Hierarchical Structure of Main Menu ...
Page 28: ...28 FASTORA DAS 208CC Disk Array 249 Partition 4 24A Del RAID Set To delete the RAID set ...