DTC1 Series
Intelligent Temperature/Humidity PID
Controller with 60 Step Program Control
User Manual V 1.0
Thank you for purchasing Fastron DTC series PID
Temperature/Humidity Controller. This manual explains
how to install and operate your new PID
Controller.
Before operation, please read this manual first to fully
understand the operation of this product. This controller
should be installed by a qualified Electrical Engineer,
Technician or Electrician. For specific technical support
please contact your agent or representative.
Safety Warning
1a)Avoid touching the AC power terminals after the controller is powered
on
.
1b)Always ensure the supply power is off first before connecting any
wires
.
1c)Do not operate this instrument in places full of explosive and
combustible gases
.
2. Incorrect Connection of the Power Supply can cause permanent
damage.
3. The maximum torque of the terminals should not exceed 8KN.
4. Please do not use in the following circumstances:
● where the temperature changes dramatically
● Places where humidity is too high (~85%) and water is produced
● Where vibration or impact is high
●Where corrosive gases or dust are present
● splash of water, oil and chemicals
6. All Wiring should be kept away from highvoltage, highcurrent power
Improved Features
(1) Slope value offset compensation.
(2) 2 in (input) 2 out (output) : 1 to 2 isolated transmission, 2 to 1 isolated transmission
(Optional)
(3) Multiple alarm modes
(4)Transmission of PV, SV and MV: forward, reverse and difference value in 8 ways.
(5) Output soft start function.
(6) Dehumidification function.
(7) Servo Motor Control (Optional)
(8) Optional 60 Segment, Multi Sequence, Program Control
Programming Menu
Wiring Configuration
Summary of Contents for DTC1 Series
Page 2: ......
