15
www.fastTT.bike
FastTT Aero Bar Installation Guide - TKP v8
On FastTT spacers, the round locator domes will ensure that the spacers align perfectly. If you
are only using our mounting spacers and not the angled wedges, then you should file off the
round locator domes on the TOP SPACER to ensure a flush fit against the bar.
Complete the
marking and drilling process.
Be careful to not stack the mount post structure too high, especially if you are using M5
(5mm). For tall stacks we recommend using a bridge to provide lateral support.
If you want to raise your bars higher, you can also fit the steerer spacers supplied with your
bike.
Fully tighten the Allen screws to the specifications of the bike manufacturer
(maximum torque
of 4nm)
. Apply a small amount of thread lock to the screws before fitting. Re-install the foam
elbow pads.
For detailed mounting information we recommend you review the Universal Mounting System
Installation Guide is available here -
https://www.fasttt.bike/guides/
SECTION D - ADJUSTING BAR HEIGHT
