8
www.fastTT.bike
FastTT Aero Bar Installation Guide - TKP v8
For ultra-narrow setups you can trim up to 12mm off
the inside edge of the paddle on each bar with a
Dremel cutting tool or hacksaw. Do not cut this
unless you absolutely need the extra space for an
ultra-narrow fitment. The paddle area is designed to
smooth the flow of air under the bars and away from
the chest area, so unnecessary removal will
negatively impact aero performance.
Carefully mark the area to cut with masking tape
before cutting. Trim the foam pad to match.
If you are using FastTT spacers or wedges,
bolt the spacers/wedges to your mounting
base from the TOP SIDE.
Trim off
12mm max
SECTION A - GETTING STARTED
