Fat Shark
7
RC Vision Systems
Power (via discharge filter supply)
The discharge filter supply allows you to power your downlink equipment from your
onboard RC pack. Connect as shown below:
AV in/out Port
RCA Connector
: Yellow: Video, White: Audio
Left, Red: Audio Right
Recording Video
Connect AV cable to AV out port on right side of headset. Connect recording
device to cables and set up as per manufacturer directions.
Note: Cables pins are not all the same (see above chart), be sure to connect to
headset using the included cable.
Using an external receiver:
Use the AV cable to connect headset to the RCA AV
port of external devices.
To share the base station power supply with your
goggles, pick up a 3m Dominator AV cable accessory
from your retailer. Note; internal receiver must be shut
off to properly display external AV.
Battery Charging
The 760 mAh 7.4V lithium polymer battery pack is equipped with a 3 pole balance
charger lead that allows the battery to be charged off standard RC battery pack
chargers (not included). Follow your charger instructions for setting up for 760 mA
7.4V Li-po. Some chargers require the discharge cable to be connected. Use the
enclosed discharge lead adapter for these types of chargers.
Ground Video AudR AuL
