Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.FattoadPro.com/Videos
Step 3
–
Push down the arms of Part A (folding mounting
arms) as seen on
Figure 3
.
Step 1 -
Take the tripod stand
and open the legs wide, push it
down as this will be the base of
the stand. Make sure to tighten
the knob where the tripod legs
meet on the stand. (See
Figure
1
). Its very important that the
legs must be spread all the way
out and down for max stability.
Step 2 -
Take
Part A
(folding mounting arms)
as labeled in the Parts
List and insert it on the
top of the main shaft
(
Part E
). The height of
Part A or the mount for
mixers is fully adjustable
by adjusting it along the
shaft where your desired
height would be. When
you
are
satisfied
on
where the mount is on
the main shaft, tighten
the knob as shown in
Figure 2
.
Step 4
–
Take
Part B
(controller mount) and slide it into
the main shaft. This is also completely adjustable to
which height you prefer. Once you are satisfied where
the controller mount is situated, tighten the knob to
secure
Part B
. (See
Figure 4
)
Step #5 -
Get
Part D
which is the boom
mount for the top
music plate (
Part C
)
and insert it through
the small post of
Part
B
, this can also be
adjusted to your
preferred height.
Tighten the knob to
secure the boom
mount as shown in
Figure 5
.
Step 6
–
Just below the
metal
music
plate
there is a knob, loosen
this to adjust the angle
of
the
plate
and
tighten to secure the
angle. (See
Figure 6
)
Step 7
–
If the book
plate is spinning from
left to right or vice
versa,
unmount
the
boom arm (
Part D
) and
push down the coupler
to where the insert is
mounted, you can use
a hammer to push it
down and secure. This
should solve the issue
of the spinning book
plate.
Step 8
–
For safety
reasons, please always
make sure to test the
stability and safety of
the product before use.
Double check all nuts
and bolts, knobs and
connectors, make sure
that these are tight and
securely
fastened
before use of your
product.
Test
the
product under light use
confirm assembly and structure of the product is correct.
