2nd edition, 31-03-2020
7000.05061, 2nd edition, 31-03-2020
7000.05061
Installation
14
4
Installation
This description must be carefully read and observed before commissioning.
Observe the environmental conditions (see chap. 2.3, p. 8).
Only trained experts and instructed persons with knowledge of the following fields may
install and commission the motors with integrated Speed Controller:
Automation technology
Standards and regulations (such as the EMC Directive)
Low Voltage Directive
Machinery Directive
VDE regulations (DIN VDE 0100)
Accident prevention regulations
4.1
Mounting
4.1.1
Mounting instructions
CAUTION!
The motor can become very hot during operation.
Place a guard against contact and warning notice in the immediate proximity of the
motor.
Ensure that adequate heat dissipation is provided.
NOTICE!
Installation and connection of the motor when the power supply is applied can damage the
device.
Prior to all aspects of installation and connection work on the motor, switch off the
power supply.
NOTICE!
The motor can be damaged if mounted incorrectly.
Observe the maximum screw-in depth of the fastening screws (see Tab. 2).
NOTICE!
Excessive loads on the motor shaft can cause irreparable damage to the motor.
When attaching parts to the motor shaft, observe the maximum permissible load values
(see the product data sheet) of the shaft.
NOTICE!
Excessive radial loads on the servomotor or excessively tightened fastening screws can
cause irreparable damage to the mounting flange.
Observe the maximum permissible radial load on the motor (see Tab. 2).
Make sure that the screws are tightened in accordance with Tab. 2.
