FAURE FHV94650XA, User Manual

3

Recommendations  

and suggestions

• The Instructions for Use apply 

to several versions of this appli-

ance. Accordingly, you may find 

descriptions of individual features 

that do not apply to your specific 

appliance.

• The manufacturer will not be held 

liable for any damages resulting 

from incorrect or improper instal-

lation.

• The minimum safety distance 

between the cooker top and the 

extractor hood is 650 mm (some 

models can be installed at a lower 

height, please refer to the para-

graphs on working dimensions 

and installation).

• Check that the mains voltage 

corresponds to that indicated on 

the rating plate fixed to the inside 

of the hood.

• For Class I appliances, check 

that the domestic power supply 

guarantees adequate earthing. 

Connect the extractor to the 

exhaust  flue  through  a  pipe  of 

minimum diameter 120 mm. The 

route of the flue must be as short 

as possible.

• Do not connect the extractor 

hood to exhaust ducts carrying 

combustion fumes (boilers, fire

-

places, etc.).

• If the extractor is used in conjunc-

tion with non-electrical appliances 

(e.g. gas burning appliances), 

a  sufficient  degree  of  aeration 

must be guaranteed in the room 

in order to prevent the backflow 

of exhaust gas. The kitchen must 

have an opening communicating 

directly with the open air in order 

to guarantee the entry of clean 

air. When the cooker hood is used 

in conjunction with appliances 

supplied with energy other than 

electric, the negative pressure in 

the room must not exceed 0,04 

mbar to prevent fumes being 

drawn back into the room by the 

cooker hood.

• In the event of damage to the 

power cable, it must be replaced 

by the manufacturer or by the 

technical service department, in 

order to prevent any risks.

• If the instructions for installation 

for the gas hob specify a greater 

distance specified above, this has 

to be taken into account. Regula-

tions concerning the discharge of 

air have to be fulfilled.

• Use only screws and small parts 

in support of the hood.

Warning: 

Failure to install the 

screws or fixing device in accord

-

ance with these instructions may 

result in electrical hazards.

• Connect the hood to the mains 

through a two-pole switch having 

a contact gap of at least 3 mm.

Use

• The extractor hood has been 

designed exclusively for domestic 

use to eliminate kitchen smells.

• Never use the hood for purposes 

other than for which it has been 

designed.

• 

Never leave high naked flames 

under the hood when it is in op-

eration.

EN