20
20. Reinstalling the pedals (swap them between
bikes)
1. Install the pedals as shown in Ch. 8
2. Correctly set the crank-arm length as in Ch. 14
3. Perform manual calibration as in Ch. 15
4. Start pedaling. As thoroughfully expalined in Ch. 16, the
product needs an initial self-calibration that will happen
during a few dozen pedal strokes.
To speed it up, we suggest you pedal seated, at a
uniform pace and on a leveled road.
21. Sensors’ LEDs behaviour
Fast and continuous blinking for
3 seconds
Assioma PRO MX is being turned on
Short blinking every 3 seconds
Assioma PRO MX is turned on
Steady
The battery is charging
Short blinking every 0.5 seconds
The battery charge is completed
Two flashes every second
Search for the associated sensor
Automatic switch off of the LED
while pedaling
While pedaling, the LED is off.
When you stop pedaling, the LED starts blinking
again.
22. Servicing
Carefully read the following user manual and the
guarantee and safety manual provided within the box
before using the product.
1. General check
To ensure the correct functioning of the product and
avoid possible accidents caused by the loosening of
the spindle, it is recommended to check periodically
or, better yet, before every ride, that the spindle is
