REC
OMMEND
ATIONS
FOR
C
ARE
AND
M
AINTENANCE
RAIDER
BA
TH
Y
12
0 MEMODEPTH
REC
OMMEND
ATIONS
FOR
C
ARE
AND
M
AINTENANCE
8
RAIDER
BA
TH
Y
12
0 MEMODEPTH
CARE INSTRUCTIONS
• Do not put your watch on any devices
thatgenerate or produce magnetic fields,
suchas loudspeakers or refrigerators.
Thesemagnetic fields can damage your
watch.
• Always rinse your watch with fresh
waterfter contact with sea or chlorinated
water. Allow leather straps to dry in the air,
never on any heating devices.
• As a precaution, avoid thermal and other
shocks.
• Always bring the crown back to position 0.
This is the only way to ensure that no
water can penetrate the case and the
movement.
• Clean metallic straps and water-resistant
cases with a toothbrush and soapy water.
Use a soft cloth for drying.
• Note that chemical products such as
solvents and detergents, perfume and
cosmetics can damage the strap, case or
seals.
• Avoid exposing your watch to extreme
temperatures (over 60°C or 140°F and
under 0°C or 32°F) and to large
temperature fluctuations.
• On the back of the watch, integrated in the
case back, you will find the protective
cover for the membrane. This can be
opened by rotating it counter clockwise by
20 degrees. The cover is used to protect
the membrane from possible damage.
Hence it should always be carefully locked
in position and opened only in case the
membrane needs to be cleaned of any
stubborn dirt or salt settlements that may
occur after a dive.
In most cases, this can be cleaned by
rinsing the chamber through the slots in the
protective cover with clear, running water. In
case there is a need to open this protective
cover to clean the membrane and the
chamber, care must be taken to not touch
the membrane with any hard, pointed, or
sharp objects. Only a soft brush and running
water should be used in such a case and
once cleaned, the protective cover, along
with the rubber seal, should be placed back
and locked in position by rotating the cover
in the clockwise direction.
Care needs to be taken that this seal used
for fastening the protective cover is also
properly placed with the protective cover to
ensure secure locking. In order not to
damage or lose the seal necessary for
fastening the protective cover, it is advisable
that opening this protective cover to carry
out such cleaning be done by an authorised
service centre. As the seal is only used to
secure the protective cover and has no
effect on the water-resistance of the watch,
however if the seal is missing or damaged
you risk losing the protective cover.
If liquids other than water, for example
beverages, enter the depth gauge chamber,
please remove the protective cover as per
the instructions written above, and rinse the
membrane thoroughly. You can undertake
such a cleaning process yourself or have it
cleaned by an official Favre Leuba Service
Center located closest to you. Do note that
any damage caused to the membrane
during cleaning is excluded from the
warranty.
Case back
Protective cover
fixing seal
Membrane
protective cover
Turn membrane
protective cover by
rotating it by 20°
counterclockwise
Fixed membrane
(not to be removed)
Case back
Protective cover
fixing seal
Membrane
protective cover
Fixed membrane
(not to be removed)
Don't damage!
RECOMMENDATIONS FOR CARE AND MAINTENANCE
