142
Jiefang J6 China IV, China V series instruction
Maintenance
Replace the centrifugal oil filter
Change cycle:
- Change the centrifugal oil filter when maintaining
oil every time (there is no need to change when the
new vehicle is first maintained). Change method:
- Unscrew the three bolts on the centrifugal oil filter
cover and remove the centrifugal oil filter cap.
- Replace with the new rotor.
- After reinstallation, make sure the tightening
torque is (6~12)Nm.
Replace the oil filter (CA6DK1 engine)
Change cycle:
- Change the oil filter element when maintaining oil
every time.
Change method:
- Rotate the oil filter cover counterclockwise, and
the oil filter element will be brought out with the oil
filter cover.
- Remove the oil filter element from the oil filter
cover and replace the new oil filter element.
- Tighten the oil filter cap clockwise with the
tightening moment of (40 + 10) Nm.
Change the lubricating oil of transmission
Oil change cycle
- When driving a vehicle for 60,000 km or 12
months (matched with the model of CA6DM3) or a
new vehicle for 40,000 km, replace the lubricant (12
gears) every 100,000 km or 12 months.
- When a vehicle travels every 10,000 km, the oil
level and leakage of the lubricating oil should be
checked and supplemented at any time. When
driving a new vehicle for 50,000 km, replace the
lubricating oil (10 gears).
When changing oil, you must first exhaust the
lubricating oil in the transmission, and then fill new
lubricating oil.
Rotor
Gas station
Summary of Contents for J6 Jiefang IV Series
