After each charging process allow the battery to rest for one
hour before taking it into service.
For resting periods of more than one month you should
always disconnect the battery. Do not forget to perform reg-
ular open-circuit voltage measurements.
NOTICE!
Exhausted batteries (batteries with formation of sul-
phate on the plates) are not covered under warranty!
Remove the vibration insulation mats (1).
Remove the battery (2) and clean the battery compartment.
Clean the outside of the battery.
Clean battery poles and pole clamps and grease them with
pole grease (Vaseline).
Check the condition of the vibration insulation mats, replace if
necessary.
On serviceable batteries check the acid level, if necessary
top up to the filling mark with distilled water.
Install battery and vibration insulation mats.
Close the battery box cover again.
6.8.2 Check, clean the air filter, replace if necessary
NOTICE!
Do not use gasoline or hot fluids to clean the air filter.
Do not continue to use a damaged air filter. If in
doubt use a new air filter.
Replace the air filter after five times cleaning, but at
the latest after half a year.
Each cleaning interval must be marked with a cross on
the cover of the air filter.
Cleaning does not make sense if the air filter element
is covered with a sooty deposit. Use a new air filter.
Incorrectly handled air filters may be ineffective
because of damage (e.g. cracks) and cause damage
to the engine.
In case of wet or oily dirt replace the filter element.
Do not run the engine without air filter.
Fig. 44
Maintenance
BPR 35/42 D - BPR 35/60 D
59
Go to
Discount-Equipment.com
to
order your parts
