3-6
FAY-003
Possible [Use Automatic Settings]
This item appears only when you set
Use this device
to [Enabled] and
allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=2F0h; IRQ=6;] [IO=2E0h; IRQ=6;]
[*Active*] Serial Port 4
Use this device [Enabled]
Allows you to enable or disable this logical device. Configuration options:
[Enabled] [Disabled]
Possible [Use Automatic Settings]
This item appears only when you set
Use this device
to [Enabled] and
allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=2E8h; IRQ=7;] [IO=3E8h; IRQ=7;]
3.3.7
Power Management
Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
The following items appear when you set Power Mode to [ATX Type].
Restore AC Power Loss [Always Off]
[Last State]
The system goes into either off or on state, whatever the system
state was.
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
RTC Wake system from S5 [Disabled]
[Disabled]
Disables system wake up from S5.
[Fixed Time]
The system will wake up at the specified hr::min::sec.
Configuration options: [Disabled] [Enabled] .
[Dynamic Time]
The system will wake up at the current time plus a specified
number of minutes.
The following items appear when Fixed Time is enabled.
Wake up day/hour/minute/second [0]
Specify the values for day/hour/minute/second.
The following item appears when Wake System with Dynamic Time is enabled.
Wake up minute increase [1]
Specify the number of minutes added to the current time before waking up
system. Input value range: [1~5]
Summary of Contents for FAY-003
Page 1: ...Industrial Motherboard FAY 003 ...
Page 9: ...FAY 003 1 4 ...
Page 40: ...FAY 003 A 3 FAQs To be added in later versions ...
