registered when they are not intended so that a sample is doubled.
Experiment with the value but try to keep the value as low as possible
to avoid retriggers.
Mask Time
0-64 (ms)
The Mask Time is mainly designed for kick drum triggers. Since the
beater of the kick pedal can sometimes rebound and hit the kick trigger
again, the Mask Time sets a time limit between triggers to avoid
sample doubling. Experiment with the setting to get the right timing
according to your playing.
Anti-Cross
1-10
This system is intended to limit any possible ‘crosstalk’ between
different triggers. This effect can occur when two triggers are mounted
on the same bracket where the vibrations caused by striking one
trigger can unintentionally activate the second trigger.
Rim Gain
5-20
The higher the value of the Rim Gain, the more sensitive the rim of the
toms becomes, and the louder the sample playback becomes when
the rim is struck, or the other way around. It’s therefore possible to set
the value so that a light touch will play back the sample at full volume.
Head/Rim adj.
5-20
It can happen that when the rim is struck, the main drum sound is
unintentionally triggered. This can happen due to the vibrational
transference of the strike. Experiment with the Head/Rim value to hit
the right balance but be aware that when set to a high value, it can be
more difficult to trigger a rim shot.
MIDI Settings
Via the Set up menu, six different MIDI parameters can be adjusted. For example, the MIDI channel can be
set, and the USB-MIDI interface can be switched on and off.
Parameter
Value
Description
MIDI channel
1-16
Select the MIDI channel
Auto Trace
ON/OFF
Switch both the Auto Trace of the master-interface and
the audio interface on or off.
Retransmit
ON/OFF
Switch MIDI signal input and output over USB on or
off.
System Real
ON/OFF
Switch System Real on or off.
USB-MIDI OUT
ON/OFF
Switch USB MIDI OUT on or off.
USB-MIDI IN
ON/OFF
Switch USB MIDI IN on or off.
Effect Setting
The drum module also offers the option of adjusting the reaction of a specific trigger or pad. For example,
both the volume response of the triggers and the panning of the sample play back can be adjusted.
The parameters that can be adjusted in detail are listed in the table below:
Parameter
Value
Description
Coarse
-24 - +24
Coarse tuning of the selected
trigger/pad
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 07-05-2020 RV Revision date + author initials:
