Scan Time
0 – 4.0 ms
The Scan Time is a function that analyses the loudness at which a
sample should be played back depending on the way that the trigger is
struck. Since each trigger will not react in the same way, in some
cases it’s necessary to adjust the Scan Time a little more so that it’s
measured at a later peak-point during the strike. Try to keep this value
as low as possible.
Retrig Level
0-16
This setting determines the maximum time between the activation of
each trigger. Retriggering means that multiple triggers might be
registered when they are not intended so that a sample is doubled.
Experiment with the value but try to keep the value as low as possible
to avoid retriggers.
Mask Time
0-64 (ms)
The Mask Time is mainly designed for kick drum triggers. Since the
beater of the kick pedal can sometimes rebound and hit the kick trigger
again, the Mask Time sets a time limit between triggers to avoid
sample doubling. Experiment with the setting to get the right timing
according to your playing.
Anti-Cross
0-80
This system is intended to limit any possible ‘crosstalk’ between
different triggers. This effect can occur when two triggers are mounted
on the same bracket where the vibrations caused by striking one
trigger can unintentionally activate the second trigger.
Rim Gain
0-8.0
The higher the value of the Rim Gain, the more sensitive the rim of the
toms becomes, and the louder the sample playback becomes when
the rim is struck, or the other way around. It’s therefore possible to set
the value so that a light touch will play back the sample at full volume.
Head/Rim adj.
0-80
It can happen that when the rim is struck, the main drum sound is
unintentionally triggered. This can happen due to the vibrational
transference of the strike. Experiment with the Head/Rim value to hit
the right balance but be aware that when set to a high value, it can be
more difficult to trigger a rim shot.
Xstick adj
-9 - +9
This determines the strength of a cross stick and open stick. If the
value is positive, the sound of the cross stick will remain audible even if
the trigger is powerfully struck.
Pedal HH Sens
-5 - +5
Adjusts the sensitivity of a connected hi-hat and a foot splash sound. If
the value is positive, the pedal sound is loud even when the pedal is
only lightly pressed.
MIDI Interface
After opening the MIDI interface, pressing F2 can be used to access the MIDI section. Use the navigation
and +/- buttons to scroll through and adjust the options as needed.
Using F1 and F2, it’s possible to switch between two pages of parameter adjustment options.
The following parameters and values can be adjusted:
Parameter
Value
Description
MIDI channel
1-16
Select the MIDI channel
Auto Trace
ON/OFF
Switch both the Auto Trace of the master-interface and
the audio interface on or off.
Retransmit
ON/OFF
Switch MIDI signal input and output over USB on or
off.
System Real
ON/OFF
Switch System Real on or off.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 07-05-2020 RV Revision date + author initials: