- 16 -
User Codes
TO ADD OR CHANGE A USER CODE
Users can be added or changed directly at the keypad. Your system can have
up to 32 different user codes, with each assigned to one of four authority
levels and to a primary partition. The authority level determines the
functions that users can perform. In addition, your system can be set up for
4-digit or 6-digit user codes. Ask your installer which type of user codes is
used in your system.
To add or change a user code, press the following:
User ID
Auth.
Master User Code
(01–32)
New User Code
Level
CODE
[1–4]
e.g., CODE
1
2
3
4
0
8
5
6
7
8
3
Authority Levels
Level Functions Allowed
1
Primary Master: access all partitions, can view log and set time, assign other
user codes, all system functions
2
Secondary Master: same as primary master except cannot change the primary
master’s code
3
User: cannot assign codes and cannot bypass zones
4
Limited user: same as level 3, except can disarm the system only if it was armed
by another user with level 4 authority (cannot disarm if armed with user of higher
authority level).
Assigning Partitions to Users
When a user code is assigned, that user is automatically allowed to perform
system functions in the partition in which the user’s code is assigned. You
can also allow users to access other partitions and turn on open/close
reporting to a pager by using the #7 command as follows:
[#] [7] [master user code] [user no.] [1, 2, or 4]
where: master user code = user with authority level 1 or 2
user no. = the user that will be assigned access to other partitions
1, 2, or 4 = the partition(s) 1-2 you want this user to have access to;
enter 4 if you want this user to send Open/Close reports to a
pager
