FBII XL-20 Hookup And Installation Instructions Download

Page: 31 / 83

XL-20 Hookup and Installation Instructions

8–2

Installer Mode 1 (RF Programming)

You can enter the RF Programming mode by pressing [*] [#] [X] [X] where [X] [X] is 01 to 14
and selects the desired RF Programming question no. See Section 10: Programming
Questions - RF Programming for specific information.

When RF Programming mode is entered, the question number LEDs will blink rapidly.

Installer Mode 3 (Unattended Download)

The Unattended Download function allows the installation of the control panel and then
have the control panel dial the telephone number of CS downloading computer so that the
control panel can be downloaded without having the operator present. Basically, the CS
downloading computer telephone number will be programmed into the callback number
(question 03) and an identification number (same as the account number in the downloader
software) will be programmed into the secondary telephone (question 02). NOTE: These are
temporary values since they will be reprogrammed after downloading.

Unattended Download requires the following sequence:

1. The PC operator must select UNATTENDED DOWNLOAD in the Downloader Software

Main Menu.

2. Enter Unattended Download mode: [CODE][*] [INSTALLER][3].

3. The system will now enter keypad programming at question 01. Enter the telephone

number of the central station downloading computer. Enter [#] after each digit; for
example: [1] [#] [2] [#] [3] [#]. You can enter up to 12 digits. This phone number should be
the same as the CS callback number (question 03 from Keypad Programming if the panel
is programmed for callback).

4. Go to programming question 02 by entering the sequence [*] [0] [2]. Enter the desired

account number, following each digit with [#]. This will be used by the CS downloading
computer to determine the proper account information to download to this subscriber. The
account number must be 6 digits in length and it is the downloaders account designator
not the account number that will be communicated to the receiver. For ID's less than 6
digits long you must enter leading 0's to make the number 6 digits long. Example: for ID
345 enter [0] [#] [0] [#] [0] [#] [3] [#] [4] [#] [5] [#].

5. Press the “STAY” key to exit Programming mode. The control panel will now dial the

downloading computer telephone number entered into the callback number. (If you have
not already selected the Unattended Communications option from the main menu of the
downloading computer, select it prior to continuing.) Upon connection with the computer
the customer account number programmed in step 3 will be obtained and the system will
perform the desired download operation. NOTE: The CS downloading computer must be
waiting in the Unattended Communications option and preprogrammed with the account
information in order for the Unattended Download to be functional.

Installer Mode 4 (On-Line Download)

In this mode, the installer can initiate a remote communications session with the CS
Downloading computer at the control panel location. Typically, a remote communications
session is initiated by the CS. On-line downloading allows the installer to call the office (from
the same telephone line as the panel), discuss the action required and allow the CS operator