175
Packing (1)
174
Brass Nozzle
173
Nozzle “Fan Jet”
172
O-Ring 5.0 x 1.5
171
Short Swirl Piece
168
Filtre
167
Suction Tube
166
Bottle O-Ring 36.0 x 4.0
165
Screw Cap
164
Valve Spring
163
Valve Plunger
162
O-Ring 3.0 x 2.7
161
Pump Cylinder
150
Retaining Disk
140
Plastic Ball
130
Clip
120
Pump Handle Guide
110
Plunger
100
Screw
90
O-Ring 5.0 x 1.5
80
Plunger O-Ring 14.0 x 3.5
70
Pressure Spring 3 bar
60
Spring
50
Swirl Cone
40
Trigger
20/30
Pump Handle with Lid
10
Sprayer Cup
Manual
Compressed Air Sprayer
50200 KPV/FPE Model
Instructions for Use – Manual Operation
•
Fill the bottle up to the “Max” indicator.
•
Insert pump assembly into the bottle, and screw-on very
tightly, so the seals can maintain sufficient pressure.
•
Extend pump plunger and stroke 20 – 30 times.
•
For spraying, press the trigger. Slowly turn the nozzle to
adjust spray pattern from fine mist to jet.
•
Always release pressure in the unit before storage.
•
Immediately after use, clean the pump sprayer with clear
water.
•
Occasionally lubricate the pump barrel with a few drops
of light oil.
Warranty
Sprayers carry a limited Warranty, which is limited to replacement of
defective part(s) only. Damage attributable to improper use, faulty
maintenance, the effects of chemicals or normal wear and tear
(Seals/o-rings) is excluded from the Warranty.
If defective, the sprayer(s) should be returned to FBS for examination with
transportation prepaid. If defects are covered by the Warranty, the least
expensive inbound/outbound charges will be borne by FBS/Manufacturer. All
returned and repairable sprayers not covered by the Warranty will be repaired/
reconditioned according to the repair fee/schedule, and charges borne by the
customer.
For more information visit our web site at
www.fbsdistribution.com
and consult with FBS for chemical compatibility before using the
sprayer.
Manufactured in Germany
FBS Distribution Co., Inc.
www.fbsdistribution.com
