9
10
Installation Complete.
Secure the cover to the box using the
four supplied screws.
Before installing the cover, apply a gener-
ous amount of silicone caulk around the
opening of the floor box (where the flange
sits) . Verify that all the perimeter has
been properly sealed.
8
Leveling the Box
CORRECT
Tile or
Carpet
When a floor covering thickness is known in advance
(tile, wood, carpet), estimating level to obtain a floor cov-
ering flushed with floor box is suggested (as shown on
the figure above) However it is not completely necessary
When concrete is flushed with box, the
cover can be applied.
When concrete is over poured, the cover
can still be applied.
Avoid this situation
***INCORRECT***
Concrete
Floor Box
Tile
Floor Box Cover
Non-Beveled Cover Installation
C12 - Installation Instructions
-
1) Depending on the thickness of
the floor covering material, level the
box as necessary to obtain a flush
finish between the cover and the
final floor level as shown on the illus-
tration.
2) Before installing the cover, apply
a generous amount of silicone caulk
around the opening of the floor box.
Verify that all the perimeter has been
properly sealed.
3) Secure the cover to the box using
the four supplied screws.
FBS FLOOR BOX SYSTEMS
25060 Hancock Ave
STE 103-125
Murrieta, CA 92562
1-800-216-8307
Questions?
1.800.216.8307
www.FloorBoxSystems.com
Questions?
1.800.216.8307
www.FloorBoxSystems.com
Questions?
1.800.216.8307
www.FloorBoxSystems.com
