SETTINGS
Long press the Edit bu on to mute the current channel, the level meter of
the output channel displays the post-fader level and does not display the
level a er mute.
EDIT bu on click into the lower level processor can edit the table
processing module output channels.
EDIT OUTPUT CHANNEL
• Rotate PARAM2 to the right to select the edit character posi on
• Click PARAM1 to confirm
Channel name edit.
Click the Edit bu on and the first item displayed is the channel name edit;
the default display, if you need to modify, please follow the following order:
• Click the channel edit bu on
• Rotate PARAM3 to the right to select characters
• Rotate PARAM2 to modify the character posi on, PARAM3 to select the
character; the maximum allowable 6 characters.
CHANNEL NAME
• Click PARAM1 to save a er modifica on
NAVIG. / PARAM. 1
PARAM. 2
PARAM. 3
ENTER
ESC
UTILITY
DIGITAL LOUDSPEAKER MANAGEMENT
Push
INPUT MATRIX
The input matrix allows the user to mix 2 input signals to any output
channel in any ra o. The knob PARAM1 selects the AB input source and the
PARAM3 adjusts the gain amount, which can be adjusted from -30 to 0 dB.
NAVIG. / PARAM. 1
PARAM. 2
PARAM. 3
ENTER
ESC
UTILITY
DIGITAL LOUDSPEAKER MANAGEMENT
PARAM. 1
PARAM. 2
On/Off
Gain
CH-1 Source
A:0dB B:OFF C:OFF D:OFF
CH-1 Source
CH - A = ON Gain = 0dB
CH-1 Source
CH - B = OFF Gain = 0dB
CH-1 Source
CH - A = ON Gain = 0dB
CH-1 Source
CH - B = OFF Gain = 0dB
CH-1 Source
CH - B = ON Gain = 0dB
Turning
Turning
PARAM. 2
PARAM. 3
NAVIG. / PARAM. 1
PARAM. 2
PARAM. 3
ENTER
ESC
UTILITY
DIGITAL LOUDSPEAKER MANAGEMENT
ENTER
PUSH
• Press PARAM1
• To rotate PARAM1, select B
The default route of processor is channel AB(CD) pass-through output
1,2,3,4,5,6,(7,8). In actual use it may be necessary to assign one input signal
to mul ple output channels, such as rou ng input channel A to output 1/2
(since output channel 1 has sent 0dB from input A by default, so directly
start from channel 2).
• Press PARAM2 to complete
• Rotate PARAM3 to adjust the gain of input A to 0dB
• Select the PARAM1 naviga on bu on to go to the source screen
• Press the select bu on for output 2
• Rotate PARAM3 to adjust the gain of input B to minus infinity
• To rotate PARAM1 , select A
15