Check for leaks
ALL JOINTS AND CONNECTIONS MUST BE LEAK TESTED BEFORE
USING THE BBQ. LEAK TEST ANNUALLY, AND WHENEVER
THE GAS BOTTLE IS REMOVED OR REPLACED.
Before use please check for leaks
Never check for leaks with a naked flame, always
use a soapy water solution
1.
Make a mixed solution (water and liquid detergent / soap).
2.
Ensure that there are no naked flames, heat sources and cigarettes in
the vicinity when performing a leak test.
3.
Check that the control valve on the BBQ is ”OFF”.
4.
Connect the regulator to the cylinder and ON/OFF valve to the
burner, ensure the connections are secure then turn ON the gas.
5.
Brush the soapy solution on to the hose and all joints. If bubbles
appear you have a leak, which must be rectified before use.
6.
Retest after fixing the fault. Turn OFF the gas at the cylinder after
testing.
7.
IF BUBBLES APPEAR, SWITCH OFF THE GAS SUPPLY AND REPAIR
THE PROBLEM. PERFORM A NEW LEAK TEST. DO NOT USE THE
BBQ BEFORE YOU ARE SURE THAT THERE ARE NO LEAKS.
8.
If detected leakage cannot be rectified, do not attempt to cure
leakage but consult your gas dealer.
!
15
Summary of Contents for CHEF's Special 3.1
