3. Assemble accumulator and connect power
③
Remove the rubber cover of the
steering rod end, connect the steering
wheel terminal to the terminal of the car
body, and put it into the wire hole of the
dashboard. Put the steering wheel into
the steel rod, and fasten it with M5x35mm
machine screw.
④
Insert the windshield into place of the
car body and press down until a "snap”
is heard.
1. Remove the rubber cover on the accumulator, and connect the power cord of
the car body to the accumulator in correct polarities. (Black cord corresponds to
black terminal (negative polarity)), red cord corresponds to red terminal (positive
polarity).
2. Connect the wire plug to connector of accumulator firmly.
Installation of accumulator(6V 7Ah)
(This accumulator installation is used for basic version)
Installation of accumulator(12V 7Ah)
(This accumulator installation is used for high version)
Red cord
Black cord
M5 Cap nut*1
M5×35mm Machine screw*1
6
