Document Number:
MAN
– FD215CV-C-TS (-1)
Rev:
B
Revision Date:
01/10/2017
Page 12 of 16
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
Touchscreen Driver
The FD215CV-C-TS and FD215CV-C-TS-1 utilize a touchscreen controller
manufactured by 3M. The touchscreen driver is supplied by 3M and FDS Avionics
Corp. recommends downloading the latest version of the driver during the installation of
the FD215CV-C-TS/-1, at the following address:
http://solutions.3m.com/wps/portal/3M/en_US/Electronics_NA/Electronics/Tools_Suppo
rt/Support/
Follow the web address above and select the operating system depending on the
platform that will be connected to the FD215CV-C-TS (-1). Any of the MT7 drivers
should work for either the FD215CV-C-TS or FD215CV-C-TS-1 as long as the correct
operating system was selected.
Make sure to follow the installation instructions and plug in the touchscreen controller
when asked by the installation software. The FD215CV-C-TS-1 driver installation may
require a reboot of the system platform after installation for the RS-232 monitoring
service to start.
The MT7 Software Users Guide can also be found at the same location as the driver
download. This document has detailed instructions on how to use and setup the MT7
touch screen software. Topics include: Calibration, Linearization, Changing the Touch
Down/Touch Up events, changing the audible beep and multi-display configuration.
