Document Number:
MAN
– FD932DVD-BLU-2 (VER X)
Rev:
D
Revision Date:
07/11/2017
Page 13 of 27
©
2017 FDS Avionics Corp.
All Rights Reserved.
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
HDMI
HDMI (High-Definition Multimedia Interface) defines the protocol and electrical
specifications for the signalling, pin-out, electrical, and mechanical requirements of cable
and connectors used for transmitting High-Definition content. The Type A HDMI
connector (shown below) has 19 pins with bandwidth to support all SDTV, EDTV, and
HDTV modes. The plug's outside dimensions are 13.9 mm wide by 4.45 mm high. There
is no audio output available on the HDMI cable.
ECS manufactures an HDMI cable that is terminated at the factory. It is ordered as part
number 600-19786-XXX, where XXX is the length in inches for the desired cable.
NOTE
: On the following Pinout page, Pin 14, 15, 16 are reserved for CAN BUS integration. The
FD932DVD-BLU-2 (VER HDSDI) is only intended to easily integrate with the FDS Avionics Select
CMS. If more information regarding the CAN BUS integration with this device is required, please
contact FDS Avionics Technical Support at 470-239-7421.