FE 150 RLX
This document is protected by copyrights.
Copying, using, or distributing without permission of Fe Powertools BV is prohibited.
4
1. GENERAL INFORMATION
1.1. Application
The FE 150 RLX is a drilling machine designed to drill holes with diameters of up to
150 mm (5.91
″) by using annular cutters. The machine can also drill holes with dia
m-
eters of up to 47 mm (1.8
5″) by using twist drill bits.
The machine can change the direction of rotation. This allows thread cutting by
using a tap chuck.
The electromagnetic base clamps the machine to ferromagnetic surfaces. This
makes sure that the operator is safe and the machine works correctly. A safety strap
protects the machine from falling in case of a clamping loss.
When the brushes are worn, the machine turns off automatically.
1.2. Technical data
Voltage
1~ 220–240 V, 50–60 Hz
1~ 110–120 V, 50–60 Hz
Power
2300 W
Spindle shank
MT4
Tool holder
19 mm (3/4″) Weldon
Maximum drilling diameter with an annular cutter
150 mm (5.91
″)
*
Maximum drilling diameter with a twist drill bit
47 mm (1.8
5″)
Maximum drilling depth
100
mm (3.94″)
Maximum tap size
M42 (1-
5/8″)
Clamping force
(surface with the thickness of 25 mm and roughness
R
a
= 1.25)
25 000 N
Electromagnetic base dimensions
105 mm × 315 mm × 50 mm
4.1″ × 12.4″ × 2″
Stroke
260 mm (10.2″)
Rotational speed under load
55–85 rpm
100–150 rpm
200–300 rpm
350–520 rpm
Minimum workpiece thickness
10
mm (0.4″)
Protection class
I
Protection level
IP 20
Noise level
More than 85 dB
Required ambient temperature
0–40°C (32–
104°F)
Weight
31 kg (68 lbs)
*
If more than 60 mm (2.36″), use an MT4 arbor with 32 mm Weldon tool holder (UCW
-583-13-00-00-
0).
If more than 130 mm (5.12
″), use only
a TCT cutter with the drilling depth of up to 50 mm.
