FE 150 RLX
This document is protected by copyrights.
Copying, using, or distributing without permission of Fe Powertools BV is prohibited.
11
3.2. Installing and removing the arbor, MT4 twist drill bit, or
tap chuck
Unplug the power cord and lift the chip guard (
1
).
Turn the handles to the right (
2
) to
lift the motor. Use petroleum ether to clean the spindle and the arbor (drill bit, tap
chuck). Then, clean them with a dry cloth.
Chips or grease in the spindle or on the Morse taper (
3
) can dam-
age the spindle.
Use gloves
and a quick movement to put the arbor (drill bit, tap chuck) into the spin-
dle (
4
).
Make sure that the stop rod is between the pin and the fitting (
5
). If the arbor
(tap chuck) has a nut (
6
), tighten the nut to the spindle. Before you install an
MT4×60 mm tap chuck, remove the stop rod (
7
).
1
2
4
6
5
7
3
