FE 150 RLX
This document is protected by copyrights.
Copying, using, or distributing without permission of Fe Powertools BV is prohibited.
19
Turn the gear switch as shown in the figure until you feel resistance. Incorrect
setting can damage the gearbox.
Steel with a strength
R
m
≥
500 N/mm
2
(70,000 psi), such as St5 (E295), 18G2A
(S355N), or 45 (C45), requires lower speeds. If the s
peed is too high or too low for
the workpiece strength and the type/diameter of the tool, the tool will wear faster or
be unable to drill the hole.
Press
to start the motor. Turn the handles to the left to put the tool into the
workpiece. Use the speed knob to set a speed sufficient for the actual process condi-
tions. Set the speed knob near the maximum.
When the annular cutter goes through the workpiece, the slug
core is pushed out with a large force.
CORRECT
✓
INCORRECT
Rotation direction
Rotation direction
