- 28 -
1.
Remove both rear doors as described in the “Door Removal” section of this manual.
2.
Remove shelving from unit through rear door opening as described in the “Shelving Installation and
Removal” section of this manual. Remove all interior shelving as described in the shelving
installation and removal section of this manual.
3.
Remove both shelf standards from interior of case by removing the (2) thumbscrew from top and
bottom.
4.
Steps 5 & 6 on refrigerated only.
5.
On Refrigerated models lift the display pan up and out of evaporator tub. Remove display pan
through rear opening. Remove the evaporator fan shroud by removing the thumbscrews along the
backside of evaporator fan shroud and on each end of evaporator coil. Lift the rear of the
evaporator fan shroud and reach in and unplug the evaporator fan motor cord. Remove evaporator
fan shroud through rear opening.
6.
Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a damp
cloth and allow to dry. (DO NOT use solvents such as Acetone, Benzene, Carbon Tetrachloride, and
Lacquer Thinners)
NOTE: Depending on the amount of usage and spillage of foreign material, some fasteners may have
to be removed and parts disassembled to allow proper cleaning of the unit.
7.
Clean all shelves, shelf support bars, shelf lights, shelf brackets, and display pans using warm soapy
water and a brush. Rinse thoroughly and allow to dry.
8.
Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant such as PAM to make the doors operate smoother.
9.
Clean both sides of the doors and interior and exterior of the front glass using any common window
cleaner. IMPORTANT: Do not allow glass cleaner to contact any of the Acrylic plastic end panels,
Acrylic plastic top panel, Acrylic plastic front lift up doors, or Acrylic plastic inner doors.
10.
IMPORTANT: Cleaning the Acrylic plastic end panels, top panel, front lift-up doors, and plastic
inner doors require special care to prevent hazing and yellowing of material. Lightly dust (not wipe)
surface with clean soft cloth. Then the surface can be wiped carefully with a soft, wet cloth or
chamois. The cloth or chamois must be kept free of grit by frequently rinsing in clean water. Grease
and oil can be removed with kerosene. Do not use window cleaners or kitchen scouring compounds.
DO NOT use solvents such as Acetone, Benzene, Carbon Tetrachloride, and Lacquer Thinners. A
spray wax such as Pledge or Maguire’s polish can be applied and wiped with a clean soft cloth. The
wax tends to fill in and hide small scratches.
11.
Reassemble the case in reverse order.
