21
Installing the Mobile Camera System
• either the
CAM1
or
CAM2
input on the input/power/
trigger wiring harness (CAMADP-INT-2) of the CAM-
LCD-INT-56/CAMLCD-INT-70 monitor or
• one of the four camera inputs on the CAMBOX-4NTSC/
CAMBOX-4PAL control box (for use with the CAM-
LCD-70 monitor) or
• one of the four camera inputs on the input/power/trigger wir-
ing harness (CAMADP-INT-4) of the CAMLCD-INT-70-B
or
b) a special DVR system camera-extension cable that is connect-
ed to one of the four camera inputs on the CAMDVR-4-B
Mounting the Flush-Mount Camera
Option 1: Mounting the camera with the included bracket
1. Align the mounting bracket on the vehicle with the drilled mount-
ing holes, and then guide the camera output cable through the
camera barrel and nuts of the mounting bracket assembly (Figure
3 on page 20).
2. Guide the camera output cable into the 3/4 in (19.0 mm) hole and
secure the rubber grommet of the cable in the hole.
3. To affix the mounting bracket to the vehicle, choose the appropri-
ate screws for the holes you drilled:
a) If you are using the self-tapping screws, guide each screw
through the camera mounting bracket, then into the drilled
holes. Fasten the screws tightly to the vehicle body.
b) If you are using the machine screws, guide each screw with
its lock washer and flat washer through the camera’s mount-
ing bracket. Install the matching nut on the opposite side of
the vehicle surface. Fasten the mounting hardware tightly to
the vehicle body.
4. Install the camera and camera barrel, while adjusting the viewing
angle, in the mounting bracket with the included short screws
(with matching lock and flat washers).
5. Connect the camera to the monitor via a camera extension cable
(one CAMCABLE-SHORT/-5/-10/-15/-20/-40 or two connected
in series with CAMCABLE-EXT) or special DVR system cam-
era cable (as applicable). To obtain the correct image orienta-