290A4772
MOUNTING
BRACKET
ASSEMBLY
1/4-20 x 5/8" HEX HEAD
MACHINE SCREW
1/4" LOCKWASHER
LOCKING
CLIP
CHILD RESTRAINT
HOOK
CUDATRIOPTIC
LIGHTHEAD
290A4773
#8 KEPS NUT (2)
SUPPLIED
WITH LIGHT
ASSEMBLED
BRACKET
Figure 1.
Figure 2.
respect to the child restraint hook located on the rear deck
of the vehicle.
2.
Tighten the hex machine screw to firmly attach
the mounting bracket to the vehicle.
3.
See figure 2. Attach the light head onto the
bracket as shown using the #8 keps nuts supplied with the
light head.
4.
Refer to instructions packaged with the control
unit for proper electrical connections.
E.
OPERATION.
SAFETY MESSAGE TO OPERATORS
WARNING
People’s lives depend on your safe use of our
products.
Listed below are some important safety
instructions and precautions you should
follow:
•
Although your warning system is operat-
ing properly, it may not completely be
effective. People may not see or heed
your warning signal. You must recognize
this fact and continue driving cautiously.
•
Also, situations may occur which ob-
struct your warning signal when natural
or man-made objects are between your
vehicle and others, such as: raising your
trunk lid. If these situations occur, be
especially careful.
•
At the start of your shift, you should
ensure that the signal is securely at-
tached and operating properly.
•
Products attached to this bracket contain
high intensity LED devices. To prevent
permanent eye damage, DO NOT stare
into the light beam at close range.
Failure to follow these safety precautions may
result in property damage, serious injury, or death to
you, to passengers, or to others.
RETAIN AND REFER TO THIS MESSAGE
F.
MAINTENANCE.
Check periodically to ensure that all bracket fasteners
are secure and that the intended light direction is main-
tained.
G.
REPLACEMENT PARTS.
Contact your local dealer/distributor for replacement
parts availability or contact the Federal Signal Service
Department at:
Service Department
Federal Signal Corporation
2645 Federal Signal Drive
University Park, IL 60466
800-433-9132
800-343-9706 (fax)
empserviceinfo@fedsig.com
-2-
