Installation and Service Instructions
5
Opening and Closing the Housing
The factory-supplied leads are strain-relieved to the cover.
HOUSING DAMAGE: Use caution and support the housing when loosening
the cover screws. The housing is not supported by any means other than
the cover screws. Once they are loosened, the housing will separate from
the cover.
Opening the Housing
Tools required: 7/16" socket, 3/8" socket,
1/4" socket and a 6" extension
1. Remove the four 1/4"-20 locknuts on
the bracket assembly to free the lower
band bracket.
2. Remove the four 1/4"-20 hex head
screws from the back of the bracket
assembly to allow the eHorn-HV to be
free of the bracket assembly
3. See Figure 4. Loosen the four cover
screws while supporting the housing so
it does not fall. (The cover screws are
retained in the housing).
Figure 4 Locations of Housing Screws
Cover Screws (4 Places)
Figure 3
eHorn-HV Bracket
Assembly