H
igH
L
igHter
™ LED Mini-Lightbars
11
Figure 1 Mounting holes for Patterns A and B
290A6029B
B 12.05"
A 12.75"
A
4.0"
B
5.21"
NOTCH
TO REAR
OF VEHICLE
KNOCKOUT FOR ADDITIONAL WIRING
EXIT FOR WIRING
LOCATIONS OF FUSES, CONNECTORS, AND
JUMPER PIN ON PCB WITHIN THE HOUSING
1.
Select the mounting-hole pattern most appropriate for your installation and scribe four drill
position marks on the mounting surface. The wire-routing hole can be located beneath the wire
exit. If the wires will be routed down, scribe a drill-position mark for the hole on the mounting
surface at the selected location. A channel is provided to run the wires to the back of the lightbar,
if needed.
2.
Drill four 9/32-inch mounting holes at the scribed drill-position marks. If required, drill one 1/2-
inch hole at the scribed mark for routing the wires. Install the grommet in the wire-routing hole.
NOTE:
If the wire needs to be routed through the mounting pad, carefully cut an opening in the pad
and route the lightbar wires through it.
3.
To complete the installation, see “Wiring the
H
igH
L
igHter
LED” on page 11 and “Completing the
Installation Directly to the Vehicle” on page 13.
Wiring the H
igH
L
igHter
LED
The permanent-mount
H
igH
L
igHter
LED has 18 inches of pre-installed lead wire. The lead wire may have
to be spliced into the harness using installer-supplied terminals. To avoid leaving a splice exposed, there is
the option of running an intact wire into the lightbar.
Accessing the Wiring
NOTE:
FASTON
®
0.187-inch receptacles fit the option tabs beneath the cover.
1.
Use a 1/4-inch driver to remove the screws securing dome (Figure 2).
2.
Lift the dome/PCB/reflector assembly off the base of the lightbar.
3.
Remove the 18-inch positive (red) and negative ground (black) wires.