16
H
igH
L
igHter
™ LED Mini-Lightbars
Table 3 CAC Title 13 flash patterns for amber models
Pattern
Number Description
Rate
(FPM)
1
Quad Flash with long fourth flash
111
2
Quad Flash
81
3
Front and Rear-Sides Quad Flash
60
4
Double Flash
75
5
Rotating
95
6
Lightning Flash
64
7
Triple Flash
90
8
The “L”
62
9
Seven Flash Strobe
81
10
NFPA Flash #1
75
11
NFPA Flash #2
120
12
Front and Rear-Sides Single Flash
75
13
Pulsed Double Flash, Alternating “L”
61
14
Split Triple Flash
61
15
Double-Quad-Single Flash
90
16
Split Double Flash
62
17
Double Quad
80
18
FedPulse
118
19
Front and Rear-Sides Double Flash
91
20
Test
n/a
Selecting a Pattern Using the Jumper Pins
1.
To access the two pins labeled PROG in the wiring compartment, remove the wire-access cover
as described in “Accessing the Wiring” on page 11.
2.
While power is applied to the power (PLUS +) and ground (MINUS –) tabs, jumper the two pins
with a conductive object such as a small screwdriver or paperclip. Each time the pins are shorted
the pattern changes to the next pattern.
3.
When you reach the pattern you want, set it in memory by allowing the
H
igH
L
igHter
LED to
display the pattern for 10 seconds.
4.
Reinstall the upper assembly on the lightbar base and secure it with the four hex-head screws.