4
Safety Messages
IP Phone for Intelligent Systems (I-IPTEL1)
Federal Signal www.fedsig.com
Safety Messages
It is important to follow all instructions shipped with this
product. Before you work on any equipment, be aware of the
hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents.
After installation, test the system to confirm that it is operating
properly. Test the system regularly to confirm that it will be
operational in an emergency. For a complete list of safety
messages, see the IP Phone for Intelligent Systems User Manual
(part number 25500824). See fedsig.com for online manuals.
General Description
The IP Phone for Intelligent Systems (I-IPTEL1) is a high-quality
IP phone that supports VoIP, Intercom, SIP, and preset buttons
for alert notification. Include the IP phone on an existing SIP
phone system, or use the phone and speaker as an isolated
flat IP network. The IP phone supports RTP multicast and DTMF
activation of pre-recorded siren tones/pre-recorded voice
messages on the Federal Signal IP series of devices.
It is easy to configure the phone with preset buttons to allow
ease of dialing and activations. When used with the Federal
Signal line of IP-based speakers, you can configure a low-cost
alerting system for industrial and campus environments. An IP
phone can call individual speakers for live Public Addresses and
then use DTMF keypad to activate pre-recorded voice or siren
tones.
The phone can multicast live PA directly to a multicast group
of speakers and then multicast DTMF control commands to
speakers to activate pre-recorded voice messages or siren
tones. This allows the creation of zones for wide areas or
specific notification groups. You can use multiple phones to
create multi-location control and activation points. Configure the
phones to allow direct SIP calls between phones and speakers
without a SIP server.
